Chemist.net Cookie Policy : We use cookies to enhance your user experience. To find out more please view our cookie policy
Volumatic Spacer Device Adult
Volumatic Spacer Device Adult is a large-volume spacer device which is intended to make it easier for you to use your inhaler effectively as you do not have to press down on the inhaler and breathe in at the same time.
Browse our full range of:
Description
Volumatic Spacer Device Adult
Volumatic Spacer Device Adult is a large-volume spacer device which is intended to make it easier for you to use your inhaler effectively as you do not have to press down on the inhaler and breathe in at the same time. It helps the medicine reach your lungs where it is needed instead of being deposited at the back of the throat where it may be less effective or may cause irritation.
Directions
Clean the Volumatic Spacer Device before first use
How to prepare the Volumatic Spacer Device for use with your inhaler
- Fit the two halves of the Volumatic Spacer Device together. Line up the notch on one half with the slot on the other (these are marked with small arrows), then press the two halves firmly together.
- Take off the mouthpiece cover from the inhaler and check inside and outside to make sure that the mouthpiece is clean and free of objects. If the inhaler is new or has not been used for a week or more, point the mouthpiece away from you and release one or two puffs into the air.
- Shake the inhaler 4 or 5 times to ensure that any loose objects are removed and that the contents of the inhaler are well mixed.
- Fit the inhaler firmly into the end of the Volumatic Spacer Device, opposite the mouthpiece. Check the mouthpiece of the Volumatic Spacer Device inside and outside to make sure that it is clean.
How to use the Volumatic Spacer Device with your inhaler
- Hold the device as shown in the leaflet. Breathe out as far as is comfortable.
- Place the mouthpiece in your mouth between your teeth. Close your lips firmly around the mouthpiece but do not bite it. Do not put your lips over the side holes of the mouthpiece, as the valve will not work.
- Press down with your finger(s) on the top of the inhaler to release one puff of medicine. Straight away take one deep steady breath or 5 normal breaths to make sure that the medicine goes into your lungs. You do not need to take the Volumatic Spacer Device out of your mouth to breathe out. You should be able to hear the mouthpiece valve ‘click’ or rattle as you breathe in and out. If you are not able to hear a rattle, hold the Volumatic Spacer Device up at an angle and try again.
- Do not squirt all your puffs in to the Volumatic Spacer Device at once and then breathe them in. You must inhale one puff at a time.
- Hold your breath; take the Volumatic Spacer Device out of your mouth and your finger from the top of the inhaler. Continue holding your breath for a few seconds, or as long as is comfortable.
- Breathe out.
- If you need to take more than one puff, remove the inhaler by tilting the top forward and repeat steps 3 to 9. Wait for around 30 seconds before taking each puff of medicine.
- After use, remove the inhaler from the Volumatic Spacer Device. Replace the mouthpiece cover to keep out dust and fluff.
- If you use more than one type of inhaler through the Volumatic Spacer Device repeat the process from step 2. There is no need to wait for more than 30 seconds between inhalers.
If you find it difficult to press down on top of the inhaler when the Volumatic Spacer Device mouthpiece is in your mouth, you may fire a puff into the VOLUMATIC Spacer Device and at once place the Volumatic Spacer Device mouthpiece in your mouth and breathe in.
If you have been given different instructions for using your Volumatic Spacer Device please follow them carefully.
Tell your doctor, nurse or pharmacist if you have any difficulties using the Volumatic Spacer Device.
With normal daily use, the VOLUMATIC Spacer Device should be replaced after 12 months of use.